If you want silicone to perform well, you need to learn how to use it correctly. When used correctly, an effective adhesive layer will be formed and various properties will be exerted. If the operation method is wrong, it will not only cause waste, but also affect the later use.
How to use organic silica gel correctly?
Before injecting glue, the base surface needs to be treated. Wipe with a clean rag to remove impurities such as dust, rust, and dirt. If necessary, professional cleaners can be used to remove excess impurities. After the solvent has evaporated, wipe it again with a clean rag to ensure that the base surface is dry and clean.
When formally sizing, fill directly against the gap. In order to reduce waste, it is recommended to cut the mouth according to the size of the gap.
What should be paid attention to when using organic silica gel?
When using adhesive, it should not be too deep. Once the gap is too deep and larger than the width, it cannot be sealed directly, and other things need to be used to fill the gap. After the operation is completed, it needs to be tidied up. Don't let the excess silicone affect the overall appearance.
In order to reduce waste, it is recommended that construction personnel inject glue in a straight line. Try not to stop during the work process, once it stops, it will cause waste and affect the aesthetics. Cooperate with powerful suppliers, such as TENSAN, which focuses on silicone research and provides customized silicone application solutions. It has a wide range of uses and can be used in new energy, military industry, medical care, aviation, ships, electronics, automobiles, and instruments. , power supply, high-speed rail and other industries.
How to clean up excess silicone?
For excess adhesive, it can be cleaned up immediately after pouring. Just wipe it clean with a rag, no time wasted. You can also wait for it to harden and clean it with a sharp blade.
Although silicone is transparent, even if it is not cleaned, it will not have much impact on the overall aesthetics. It is still recommended that the operator clean it up, in case the surface of the component is not smooth enough, it may affect the stability.
