After the electronic potting compound is cured, it will be soft and not hard. This is because the adhesive is not completely cured within a fixed time or the curing speed is slow, so you need to pay attention in advance so as not to affect the effect of later use.
How to prevent the electronic potting glue from not drying or drying slowly?
Prepare before picking up materials
Use a dry container and stirring rod without moisture or moisture. If possible, warm the container and stir bar slightly. At the same time, ensure the accuracy of the measuring instruments, adjust the glue in strict accordance with the specified ratio, and mix evenly.
Use a suitable container
Some users think that they have chosen a reliable container, but they do not know that the container will also affect the curing effect. Do not use wooden or paper containers, as there will be micropores in this container, which will bring in moisture and air during the stirring process, which will affect the curing effect. You can choose containers made of metal or plastic glass. The smooth surface can reduce the entry of water and moisture, and will not affect the curing effect.
The mixing process is very important
When mixing materials, do not ignore the materials on the wall and bottom, and mix them evenly. If the time is not very tight, you can mix the two groups of materials evenly, and then put them in another container for stirring, the curing effect will be better. Cooperate with powerful suppliers, such as TENSAN, which focuses on the research of electronic potting adhesives, and provides customized electronic potting adhesive application solutions. It has a wide range of uses and can be used in new energy, military, medical, aviation, shipping, electronics , automobiles, instruments, power supplies, high-speed rail and other industries.
Adjust the curing speed according to the requirements
If it is a 1:1 addition-type electronic potting glue, it can be properly heated to speed up curing. If it is a 10:1 condensation potting compound, you can increase the air humidity to speed up the curing time.
In order to fully cure the electronic potting adhesive, or to speed up the curing time, it is necessary to start from the above aspects. Don't feel troublesome, only by paying attention to every detail can the adhesive be completely cured, so as to exert greater value.