For a long time, sealant manufacturers have been working hard to develop new products, add more functions, and make them better serve the majority of users. With the continuous increase of the performance of adhesives, the application occasions are becoming wider and wider, which has greatly benefited many industrial fields.
Are there many occasions where the sealant is used?
At present, sealants can be used in industries related to electronic components, such as automobiles, electronics, aviation and new energy. Protect large and small components and play a protective value. At the same time, the circuit board can be sealed to minimize the possibility of accidents and improve the safety factor. Choosing high-quality products and cooperating with powerful suppliers will give you more peace of mind. You can not only focus on sealant research, but also provide customized sealant application solutions. They are widely used and can be used in new energy, military industry, medical treatment, aviation, and ships. , electronics, automobiles, instruments, power supplies, high-speed rail and other industries.
What is the use of sealant?
1. Treat the base surface. Many bonding base surfaces have impurities, which can easily affect the adhesion. It can be wiped with a professional cleaning agent to keep the base surface clean and tidy. Grind if necessary to increase roughness.
2. Apply glue. Mix the two groups of materials AB according to the scientific ratio and stir them evenly. When the color is consistent, apply it within the specified time.
3. If you apply it directly, just keep the glue layer even. If the gap is potted, the adhesive layer should not be too thick, otherwise it will affect the curing speed and effect.
4. It is best to operate at room temperature. Once the temperature is lower than 15 degrees, it is recommended to heat it appropriately. During the heating process, the temperature should be controlled reasonably so as not to affect the overall effect.
This is the correct operation procedure of the sealant. During the operation, the two groups of materials must be mixed evenly. After successful mixing, an even application can be made. Once the materials are mixed unevenly, it may affect the later operation and use. If the operation method is not correct, it will affect the later effect and directly cause waste.
